Filter
Top Products
Chapter 6 Interfaces
ZyWALL (ZLD) CLI Reference Guide
73
6.3.2.1 Port Grouping Command Examples
The following commands add physical port 5 to representative interface ge1.
The following commands set port 1 to use auto-negotiation auto and port 2 to use a 10 Mbps
connection speed and half duplex.
6.4 Virtual Interface Specific Commands
Virtual interfaces use many of the general interface commands discussed at the beginning of
Section 6.2 on page 57. There are no additional commands for virtual interfaces.
6.4.1 Virtual Interface Command Examples
The following commands set up a virtual interface on top of Ethernet interface ge1. The virtual
interface is named ge1:1 with the following parameters: IP 1.2.3.4, subnet 255.255.255.0,
Router# configure terminal
Router(config)# show port-grouping
No. Representative Name Port1 Port2 Port3 Port4 Port5
=========================================================
1 ge1 yes no no no no
2 ge2 no yes no no no
3 ge3 no no yes no no
4 ge4 no no no yes no
5 ge5 no no no no yes
Router(config)# port-grouping ge1
Router(config-port-grouping)# port 5
Router(config-port-grouping)# exit
Router(config)# show port-grouping
No. Representative Name Port1 Port2 Port3 Port4 Port5
=========================================================
1 ge1 yes no no no yes
2 ge2 no yes no no no
3 ge3 no no yes no no
4 ge4 no no no yes no
5 ge5 no no no no no
Router(config)# port status Port1
Router(config-port-status)# negotiation auto
Router(config-port-status)# exit
Router(config)# port status Port2
Router(config-port-status)# duplex half
Router(config-port-status)# speed 10
Router(config-port-status)# exit
Router(config)# exit