Filter
Top Products
Chapter 41 Reports and Reboot
ZyWALL (ZLD) CLI Reference Guide
325
41.2 Email Daily Report Commands
The following table identifies the values used in some of these commands. Other input values are
discussed with the corresponding commands.
Use these commands to have the ZyWALL e-mail you system statistics every day. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
show report packet size statistics
{interface_name} [interval interval]
Displays the specified interface’s packet size distribution statistics. You
can also specify the packet size interval into which to group the
statistics.
interval: 128, 256, or 512 (bytes)
report packet size statistics clear Clears the packet size statistics data for all interface.
Table 196 Packet Size Statistics Commands (continued)
COMMAND DESCRIPTION
Table 197 Input Values for Email Daily Report Commands
LABEL DESCRIPTION
e_mail An e-mail address. You can use up to 80 alphanumeric characters, underscores (_),
periods (.), or dashes (-), and you must use the @ character.
Table 198 Email Daily Report Commands
COMMAND DESCRIPTION
show daily-report status Displays the e-mail daily report settings.
daily-report Enters the sub-command mode for configuring daily e-mail
reports settings.
[no] activate Turns daily e-mail reports on or off.
draw-usage-graphics Has the report e-mail include usage graphs.
smtp-address {ip | hostname} Sets the SMTP mail server IP address or domain name.
[no] smtp-auth activate Enables or disables SMTP authentication.
smtp-auth username username password password Sets the username and password for SMTP authentication.
no smtp-address Resets the SMTP mail server configuration.
no smtp-auth username Resets the authentication configuration.
[no] smtp-port <1..65535> Sets the SMTP authentication port. The no command deletes
the setting.
mail-subject set subject Configures the subject of the report e-mails. Spaces are
allowed.
no mail-subject set Clears the configured subject for the report e-mails.
[no] mail-subject append system-name Determines whether the system name will be appended to the
subject of the report e-mails.
[no] mail-subject append date-time Determines whether the sending date-time will be appended
at subject of the report e-mails.
[no] mail-from e_mail Sets the sender e-mail address of the report e-mails.
[no] mail-to-1 e_mail Sets to whom the ZyWALL sends the report e-mails (up to five
recipients).
[no] mail-to-2 e_mail See above.