Filter
Top Products
Chapter 38 System Remote Management
ZyWALL (ZLD) CLI Reference Guide
291
This command displays Telnet settings.
38.7 Configuring FTP
You can upload and download the ZyWALL’s firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client.
38.7.1 FTP Commands
The following table describes the commands available for FTP. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
Router# configure terminal
Router(config)# show ip telnet server status
active : yes
port : 23
service control:
No. Zone Address Action
========================================================================
Router(config)#
Table 174 Command Summary: FTP
COMMAND DESCRIPTION
[no] ip ftp server Allows FTP access to the ZyWALL. The no command disables FTP access to the
ZyWALL.
[no] ip ftp server cert
certificate_name
Sets a certificate to be used to identify the ZyWALL. The
no command resets
the certificate used by the FTP server to the factory default.
[no] ip ftp server port <1..65535> Sets the FTP service port number. The
no command resets the FTP service port
number to the factory default (21).
[no] ip ftp server tls-required Allows FTP access over TLS. The
no command disables FTP access over TLS.
ip ftp server rule
{rule_number|append|insert
rule_number} access-group
{ALL|address_object} zone
{ALL|zone_object} action
{accept|deny}
Sets a service control rule for FTP service.
address_object: The name of the IP address (group) object. You may use 1-31
alphanumeric characters, underscores(
_), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
zone_object: The name of the zone. For the ZyWALL USG 300 and above, use
up to 31 characters (a-zA-Z0-9_-). The name cannot start with a number. This
value is case-sensitive.
The ZyWALL USG 200 and lower models use pre-defined zone names like DMZ,
LAN1, SSL VPN, WLAN, IPSec VPN, OPT, and WAN.
ip ftp server rule move rule_number
to rule_number
Changes the index number of a service control rule.
no ip ftp server rule rule_number Deletes a service control rule for FTP service.
show ip ftp server status Displays FTP settings.