Filter
Top Products
Chapter 21 Anti-Virus
ZyWALL (ZLD) CLI Reference Guide
174
21.2.1 General Anti-virus Commands
The following table describes general anti-virus commands. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
Note: You must register for the anti-virus service before you can use it (see Chapter 5 on
page 45).
21.2.1.1 Activate/Deactivate Anti-Virus Example
This example shows how to activate and deactivate anti-virus on the ZyWALL.
21.2.2 Zone to Zone Anti-virus Rules
The following table describes the commands for configuring the zone to zone rules. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 92 General Anti-virus Commands
COMMAND DESCRIPTION
[no] anti-virus activate Enables anti-virus service. Anti-virus service also depends on anti-virus service
registration.
show anti-virus activation Displays anti-virus service status.
[no] anti-virus eicar activate Turns detection of the EICAR test file on or off.
show anti-virus eicar activation Displays whether or not detection of the EICAR test file is turned on.
anti-virus reload signatures Recovers the anti-virus signatures. You should only need to do this if instructed to
do so by a support technician.
[no] anti-virus skip-unknown-
file-type activate
Sets whether or not anti-virus checks files for which the ZyWALL cannot identify a
type.
show anti-virus skip-unknown-
file-type activation
Displays whether or not anti-virus checks files for which the ZyWALL cannot identify
a type.
anti-virus mail-infect-ext
activate
Has the ZyWALL add a notification text file to an e-mail after destroying a virus-
infected e-mail attachment.
no anti-virus mail-infect-ext
activate
Has the ZyWALL not add a notification text file to an e-mail after destroying a virus-
infected e-mail attachment.
Router# configure terminal
Router(config)# anti-virus activate
Router(config)# show anti-virus activation
anti-virus activation: yes
Router(config)# no anti-virus activate
Router(config)# show anti-virus activation
anti-virus activation: no
Router(config)#
Table 93 Commands for Zone to Zone Anti-Virus Rules
COMMAND DESCRIPTION
anti-virus rule append Enters the anti-virus sub-command mode to add a direction specific
rule.
anti-virus rule insert <1..32> Enters the anti-virus sub-command mode to add a direction specific
rule.