Filter
Top Products
5 Setup 97
{Dim. Dbl. Offset}
This allows you to set the address offset for dimmer doubling. The default for this is 20000, to match
the Net2 standard offset, including Sensor dimming software. For dimmer doubling over Local
DMX, this value should be set to 256.
{Partitioned Control}
Enables or disables the assigning of partitions. Default is “Disabled” (see Using Partitioned Control,
page 329 for more information).
{Home Preset}
Allows you to specify a preset that will be used as the home level for all non-intensity parameters
stored in the preset, instead of the fixture library defaults. This preset will be applied for all “Go to
Cue Out” and home commands. Intensity values in the preset will be ignored. Channels not
included in the assigned home preset will continue to home to their library defaults.
{Allow HS Fades}
Hue and saturation (HS) color data normally fades in native space. Enabling {Allow HS Fades} will
make HS data fade in HS space.
{Auto-Mark}
This toggles the AutoMark settings between enabled and disabled (see Using Mark, page 191 for
more information). AutoMark is disabled by default.
{Mark Time}
This field allows you to set the time that non-intensity mark instructions will use. When {Mark Time}
is disabled, which is the default, mark instructions will use cue timing.
{Startup Macro}
This field allows you to set up a startup macro that will trigger after the console initialization has
completed.
{Disconnect Macro}
This field can be use for disconnect macros or shutdown macros.
• Disconnect Macro - allows you to set up a disconnect macro that will trigger when the primary
disconnects from its backup, or when a backup disconnects from the primary.
• Shutdown Macro - allows you to set up a disconnect macro that will trigger at power off, not
when exiting the application.