Filter
Top Products
144 Ion Operations Manual
Using Filters with Palettes
Filters can be used to modify what data is stored to a palette by a record action. The parameters
that are active or filtered allow those parameters to be stored to record targets.
To filter a parameter:
Step 1: Click the {Filter} button in the top-right corner of the parameter grid in the CIA.
Step 2: In the CIA, click the button for the parameter you wish to store.
Step 3: Click the {Filter} button again to stop filter selection. “Filter On” appears next to the
parameter category label in the CIA.
To determine which parameter is filtered in the category:
Step 1: Click the {Filter} button in the top-right corner of the parameter grid in the CIA. All
actively filtered parameters are highlighted in gray. You may need to click the arrow
button in the grid for that parameter category to page to additional parameters in the
category.
Filters are a toggle state. To remove filters, click {Filter} and then click the highlighted parameter
buttons in the CIA to deactivate the filters, or use {Clear Filters}.
For more information on filters, see Using Filters, page 199.