Filter
Top Products
338 Ion Operations Manual
Calibrate ETC External Touchscreens
Allows you to calibrate an ETC touchscreen. With the touchscreen connected, press the {Calibrate
ETC External Touchscreen}.
The first display will have you touch various parts of the display to make sure the cursor follows your
finger and the second will have you touch some targets.
Monitor Arrangement
Ion allows for up to two monitors. The first time Ion boots with two monitors, it may not display
output to both. You will need to configure the monitors in {External Monitor Arrangement} under
{General} in the ECU.
The Monitor Arrangement Tool will dictate how and where the pointer moves from one screen/
monitor to another. Generally speaking, you will want the logical placement on this screen to match
your physical placement.
Buttons available in the External Monitor Arrangement display are:
• {Identify} - displays the video port numbers that your monitors are connected to on the
physical monitors to confirm where you have placed them.
• {Enabled} - When checked, the monitor is available for use. The desk will display the
{Enabled} box checked for any monitors it recognizes.
• {Elo Monitor Settings} -See “Elo Touchscreen Settings” on page 347.
• {Primary} - selects which monitor will display the ECU and Central Information Area (CIA).
• {Resolution} - sets how many pixels the monitor will display.
Note:
Before you calibrate your external touchscreens, you may need to first use the
External Monitor Arrangement display. See “Monitor Arrangement” on page 338.
Note:
The selected monitor will display in yellow. Monitors can be dragged to any of the
surrounding black boxes to mimic actual monitor layout.
The number on the
monitors matches the
number of the video port
on the rear of the desk.
If monitor is displayed in
gray, it is not currently
enabled.
Selected monitor
is not enabled.