Filter
Top Products
14 Working with Multiple Cue Lists 207
Using [Go To Cue] with Multiple Cue Lists
[Go To Cue] defaults to the currently selected cue list. [Go to Cue] is a live function. It can not be
used to change cues in blind. [Go to Cue] instructions can be executed from any operating mode,
without returning to live.
By default, a Go to Cue instruction is an out-of-sequence cue and will follow the rules of such (see
Out-of-Sequence Cues, page 218).
For examples of how to use [Go To Cue] in playback, please see Go To Cue, page 218.
Using Go To Cue 0
[Go To Cue] [0] is a command line instruction that resets all intensity values not owned by another
fader to default, including any manual values that are not an override to another active fader value.
[Go To Cue] [0] [Enter] also resets the selected cue list to the top of the list, with the first cue
pending.
To [Go To Cue] [0] on another cue list, press:
• [Go To Cue] [2] [/] [0] [Enter]
Captured channels, independent values and values from other faders running a different cue list
are not affected by a [Go To Cue] [0] command.
When [Go To Cue] [0] is executed, any intensity values owned by the associated cue will fade out,
while all non-intensity parameters remain in the current state. A [Go To Cue] [0] instruction does
not impact the input from other programmers using partitioned control, unless the channels or
parameters are shared.
[Go To Cue] [0] & [Load]
You can use [Go To Cue] [0] in conjunction with a fader load button to send a specific cue list to cue
0. This action does not use the command line. On the desired fader, simply press:
• [Go To Cue] [0] & [Load]
Using Go To Cue Out
To reset all parameters to their default state (unless they are controlled by a submaster) and reset
all cue lists that are loaded to faders so that the first cue of each list is pending, press:
• [Go To Cue] [Out] [Enter]
Note:
Ion has an added intensity parameter for LED fixtures, that by manufacturer
default, have only RGB parameters but no intensity parameter. With this added
control, the LED fixture will respond to the [Go To Cue] [0] command.