Filter
Top Products
4 Patch 77
• {Address} - A required entry field for any device. You may use [At] instead of the {Address}
button.
• Use the keypad to define the starting address for the device (from 1 to 65536) or a port
and offset value.
• You may enter a start address without defining an end address. Ion will draw this
information from the library data. If you wish to leave a larger output gap than required
by the library, use [Offset]. See Using {Offset} in Patch, page 67.
• If you specify a start address that conflicts with other channels already patched, the
conflicting channels will be unpatched after a confirmation is provided by the user.
• {Interface} - An optional field used to specify what network interfaces should be used for the
output. When the field is left blank, the default data output is used as selected in the
{Network} and {Local I/O} sections of the ECU. For more information about setting defaults
see Output Protocols, page 342 and Local DMX Outputs, page 351. The interface options
available are sACN, Net 2- EDMX, ArtNet, Avab UDP, and Local DMX, depending on what has
been enabled in the {Network} and {Local I/O} sections of the ECU for the desk. If an output
option is not enabled, it will not appear in the {Interface} list.
• {Flash} - will bring a channel or address to full, and then every other second the level will
move to 15%. That will hold for 1 second, and then the level will return to full. The channel or
address will keep flashing until either the command line is cleared or {Flash} is selected
again.