Filter
Top Products
6 Basic Manual Control 117
Encoder LCD screen
The encoder LCD displays the active parameter category loaded on the encoders, as selected by
the page buttons. Each encoder has an associated control section in the LCD that provides visual
indication of:
• The parameter it controls.
• The current setting (value) of the parameter.
For Example:
The above graphic shows the encoder LCD displaying the focus parameters for a moving
light.
• Encoder 1 is controlling pan.
• Encoder 2 is controlling tilt.
• Encoder 3 is controlling position MSpeed.
• Encoder 4 is not assigned.
Pressing a different encoder page key loads the encoders with other parameters of that type (if
available).
Note:
Pressing [Shift] & [Encoder Page Key] will post that parameter to the command
line. For example, pressing [Shift] & [Color] would place Color on the command
line.
Encoder
wheel 1
Encoder
wheel 2
Encoder
wheel 3
Encoder
wheel 4