Filter
Top Products
2- 41
Adjusting the Height of the Printhead
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
4
Open the upper cover when you see Open
UpperCover, then Chng Head Hght is
displayed.
Important
z Do not touch any areas other than those indicated.
Your hands could get dirty or this could damage the
printer.
z If the printhead height adjustment lever is dirty, before
continuing with this procedure, wring out a damp cloth
and use it to clean the printhead height adjustment
lever. (→ P. 4 -11 )
5
Adjust the height of the printhead with the
printhead height adjustment lever.
When printing on CAD Plain Paper, CAD Tracing
Paper, CAD Translucent Matte Film, set the lever to
the low position (a), when printing on Canvas
SemiGlos set the lever to the high position (c), and
for all other media set the lever to the middle (b)
(standard). If the printhead is scratching the surface
of media that ripples or wrinkles easily, rather than
use the recommended printhead height for that
media, set the lever one step higher.
6
Raise the upper cover stopper to release the
lock then close the upper cover.
The carriage returns to the home when you see
Carriage Moving. The printer returns to the print
ready status.
c
b
a