Canon W6400 Digital Camera User Manual


 
4- 32
Transporting the Printer
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Transporting the Printer
Before you transport the printer, follow the procedure below
to prepare the printer for shipping so its internal
mechanisms are protected. To pack the printer for
transport, refer to the Quick Start Guide and follow the
installation procedure in reverse order.
(Quick Start Guide)
Important
z Before you move the printer always perform this
procedure by executing the Move Printer menu and
following the instructions on the display. The printer
could be damaged if you attempt to move it after
disconnecting the power cord before switching off the
printer. If you accidentally disconnect the power cord
before switching the printer off, reattach the power
cord, reinstall the ink tanks, then perform the
procedure again from Step 1. (Quick Start Guide)
z You cannot execute Move Printer once the MTCart
Full Soon or Replace MT-Cart appears. You can
execute Move Printer after the maintenance cartridge
has been replaced.
z Never tilt the printer while you are moving it. This could
spill ink inside the printer and foul the work area.
z If you cannot avoid tilting or standing the printer on end
in order to move, please contact the dealer where you
purchased the printer or the nearest service center.
1
If the printer power is off, press the Power
button to switch the printer on.
Within a short time, Online or Offline is displayed.
2
Press the Online button to display MAIN
MENU.
3
Press [] or [] to select Maintenance,
then press [
].
4
Press [] or [] to select Move Printer
then press [
].
MAIN MENU
Maintenance
Maintenance
Move Printer
Data
Information Power
Offline
Menu
Message
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)
MAIN MENU
Head Cleaning
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)