Filter
Top Products
5- 47
Initializing the Settings
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Initializing the Settings
Follow the procedure below to use the Web browser
(Remote UI) to restore all the network settings to the default
values set before shipping the printer from the factory.
Note
z In addition to using the Web browser to restore the
initial settings, you can also use GARO Device Setup
Utility or the printer operation panel to restore the
network default settings.
1
Start the Web Browser, enter the following
URL for the Location or the Address, then
press the Enter key.
http://<Printer IP Address or name>/
Entry Sample : http://XXX.XXX.XXX.XXX/
2
Click and select Administrator Mode then
click the Logon button.
English is set as the default display language for the
Remote UI mode. Select Administrator Mode, then
click the Logon button.
The Remote UI starts.
Note
z If a password has been set for the printer, enter the
password and then click the OK button. If no password
has been set, then no password entry is required.
3
From the Device Manager menu on the left,
select Network.
4
Click the Reset to Default settings button.
5
Confirm the message then click the OK
button.
All the network information is restored to the factory
default settings.
Note
z When you initialize all the network settings, the printer
IP address is also restored to its factory default
(0.0.0.0) so the Remote UI screen cannot be displayed
in the browser again. Use the GARO Device Setup
Utility or the printer operation panel when you need to
perform the network settings again.