Filter
Top Products
5- 10
TCP/IP Network Settings (Windows, Macintosh, UNIX)
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Setting with the ARP/PING Command
To perform the setting with the ARP/PING command,
you need the MAC address of the printer. The MAC
address can be found printed on the status print or on
the seal attached to the expansion board, or on the
Information menu displayed on the printer operation
panel.
z Checking the Printer MAC Address
Perform the procedure below to print a Status Print so
you can check the MAC address. Before printing, set a
roll of media larger than A3.
Note
z The MAC address can be found printed on the nozzle
check pattern or the printhead adjustment pattern, or
on the printer operation panel: MAIN MENU >
Information > MAC Address.
1
If the printer power is off, press the Power
button to switch the printer on.
After a few moments, Online appears in the display.
2
Press the Online button to display MAIN
MENU.
3
Press [] or [] to select Test Print then
press [
].
4
Press [] or [] to select Status Print,
then press OK button.
The information about the printer settings is printed.
After the nozzle check pattern has printed Online is
displayed in the operation panel and the printer is
ready to print.
Data
Information Power
Offline
Menu
Message
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)
MAIN MENU
Test Print ↓
Test Print
Status Print
MAIN MENU
Head Cleaning
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)