Filter
Top Products
5- 14
TCP/IP Network Settings (Windows, Macintosh, UNIX)
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
13
Press [] once then press [] or [] to
select Default G/W then press [
].
14
Press [] or [] to change the number
setting of the default subnet mask, then
press OK button.
15
To enter the default gateway IP address,
press [
] or [] to select the number to
change, then press OK button.
The selected digit increments by 1 every time you
press []. However, at 255 the number rolls up to 0.
The selected digit decrements by 1 every time you
press []. However, at 0 the number rolls up to 255.
16
Repeat Steps 14 to 15 to enter the default
gateway IP address.
Now you are ready to register the IP address, subnet
mask, and default gateway setting.
17
Press the [] button 3 times.
Store Setting is displayed.
18
Press the OK button.
If you want to cancel the setting, press Stop button
for at least 1 second.
The printer restarts after Storing appears on the
display.
When you are finished with the settings, the printer
returns Online.
If an error occurs, check the settings then set them
again.
Important
z If you need to change the IP address, subnet mask, or
default gateway, you must perform Step 18 to register
the setting. If the setting is not registered, the entered
value will not be enabled.
IP Setting
Default G/W ↓
Default G/W
=0.0.0.0
Default G/W
=XXX.0.0.0
Default G/W
=XXX.XXX.XXX.XXX
Store Setting
OK?