Filter
Top Products
6- 31
Unexpected Printing Results
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Abnormal Content
Broken lines are visible.
Problem1: The printhead has not been aligned correctly.
Solution1: Use the printer operation panel to align the
printhead. (→ P.4-40)
Problem2: After switching the black ink type, the position of
the printhead occasionally slips.
Solution1: Align the printhead.
Random, bizarre characters are printing.
Problem1: Data from the print job data stream has been
lost.
Solution1: Switch the printer and computer off, then switch
them on again and start the print job again.
Problem2: Another printer driver was selected for the print
job.
Solution1: Select the correct printer driver for the printer
and try again. (→ P.1-32)
Problem3: The fonts of the printed data are deranged.
Solution1: Make sure that the software application you are
using has the correct type of fonts and that they
have been installed correctly.
(→ Software Application Instructions)
Length for the media feed method is not correct.
Problem1: Band Joint is selected.
Solution1: If you want to match size the media feed
direction correctly, select Print Length for the
Feed Priority item, then enter the setting for the
Adjust Length. The amount of media feed can
be adjusted in 0.02% increments.
Printing in Monochrome
Problem1: The printer driver's Color Mode is set to
Monochrome (Photo), Monochrome, or Black
Only.
Solution1: Select Color for the Color Mode in the printer
driver and try again.
(→ Printer Driver Online Help)
Problem2: Color ink tank nozzle is clogged.
Solution1: Print a nozzle check pattern to confirm the
condition of the printhead. If a print head nozzle
is blocked, perform the printhead cleaning
procedure. (→ P.4-36, P. 4-3 8)