Filter
Top Products
4- 42
Adjusting Amount of Media Feed
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Adjusting Amount of Media Feed
Perform the procedure below to perform
Adjust Band
to
adjust the amount of line feed if you see white lines or dark
color lines in your printed images. As the band adjustment
pattern prints, the printer reads the results of the print and
automatically adjusts the settings of the amount of line feed for
the media currently loaded in the printer. Before you perform
the band adjustment, make sure a roll or cut sheet A3 (L) size
or wider is loaded in the printer.
Important
z Before you adjust line feed, you must use the
operation panel to select media type for the paper
loaded for printing. If the value of the media type
selection does not match the paper loaded for printing,
you will not achieve good print results and the quality
of the printing will be poor.
z Select Feed Priority > Band Joint in order to perform
Adjust Band.
Note
z If you are using cut sheets, make sure at least one
sheet of unused A3 paper (not the blank sides of used
paper) or larger are set.
z There is no automatic adjustment for highly
transparent film. Execute Fine Tuning to perform the
adjustment with manual entry. (→ P. 4-4 3 )
Media Feed Adjustment Procedure
1
If the printer power is off, press the Power
button to switch the printer on.
Within a short time, Online or Offline is displayed.
2
Press the Online button to display MAIN
MENU.
3
Press [] or [] to select Adjust Printer,
then press [
].
MAIN MENU
Adjust Printer ↓
Data
Information Power
Offline
Menu
Message
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)
MAIN MENU
Head Cleaning
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)