Filter
Top Products
1- 25
Function Menus
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
NetWare Sets the network interface for NetWare
protocol. After setting each TCP/IP item,
select Store Setting to save the settings and
enable them. This menu is displayed only
when the network interface is installed.
(→ P.5-35)
NetWare
Off*, On Determines whether NetWare protocol is
used.
Frame Type Auto Detect, Ethernet 2, Ethernet
802.2*, Ethernet 802.3, Ethernet
SNAP
Selects the frame type to use.
Print Service Bindary Pserver, RPrinter, NDS
Pserver*, NPrinter
Selects the print service.
AppleTalk On, Off*,
Determines whether AppleTalk protocol is
used. After setting each TCP/IP item, select
Store Setting
to save the settings and enable
them. This menu is displayed only when the
network interface is installed. (
→ P.5-30
)
Ethernet Driver Sets the method of communication for the
network interface board. After setting each
TCP/IP item, select Store Setting to save
the settings and enable them. This menu is
displayed only when the network interface is
installed. (→ P.5 - 6)
Auto Detect On*, Off Automatically recognizes the LAN
communication protocol. If set to Off, the
communication method or Ethernet type are
enabled.
Comm. Mode Half Duplex*, Full Duplex Selects the LAN communication method.
Ethernet Type 10 Base-T*, 100 Base-TX Selects the LAN communication speed.
Spanning Tree Not Use*, Use This selection determines whether the LAN
spanning tree signal is received.
MAC Address Displays the MAC address of the network
interface board.
Menu Item Setting Values Function