Filter
Top Products
1- 28
Function Menus
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Roll Length Set ## m (meter selected for Length
Unit), ## feet (feet/inch selected for
Length Unit), Manual Setting,
Unknown
When the roll supply remaining detection
function is
On
, the printer sets the media length
when the roll media loaded has no bar code.
This is displayed only when
Chk Remain. Roll
is
On
. Some
Length Units
are displayed in
meters, and others in feet depending on the
setting. Also, if
Manual Setting
is selected you
can enter the length directly.
If
Unknown
is selected, the roll supply remains
function is switched
Off
.
Nozzle Check 1 page, 10 pages*, Nozzle check Allows you to set the number of patterns to
print when a nozzle clogs during an
automatic check.
Stop Ink Check Bk Ink Tank
PC Ink Tank
C Ink Tank
PM Ink Tank
M Ink Tank
Y Ink Tank
Switches off the ink level detection function.
(→ P. 4 - 8)
Sleep Timer
5 min., 10 min., 15 min.*, 20 min.,
30 min., 40 min., 50 min., 60 min.
Sets the amount of time the printer remains
idle before it enters sleep mode.
Use Power Save On, Off Sets up the printer sleep mode function. If
set to On the printer enters the Sleep Timer
mode to reduce its power consumption and
conserve energy if the covers are closed and
the printer is neither operated nor receives a
print job after the prescribed time has
elapsed. If set to Off, sleep mode is
disabled. (→ P. 1 -9 )
Length Unit meter*, feet/inch Sets the units used to display the length of
the roll sheet on the display. The units for the
roll length display and the roll supply
remains display are separate.
Menu Item Setting Values Function