Filter
Top Products
6- 37
Handling Jams
TOP
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Index
Contents
Chapter 2
Using a Variety of
Media
Chapter 1
Basic Procedures
Important
z Do not pull strongly on the roll media when you align it
with the guideline. The roll media may not feed out
straight in some cases.
z If you pull too much of the roll media out, more of the
leading sheet than is needed will be cut.
7
Move the carriage manually when it is out of
its normally parked position.
Push the carriage to the right until it stops.
Important
z Be sure to push the carriage to the right. If you push it
to the left, the printer will display a carriage error after
the printer is switched on.
8
Raise the upper cover stopper to release the
lock then close the upper cover.
9
If the printer is off, press the Power button to
switch the printer on.
The media starts to feed, and the printer is ready to
use after feeding is finished.
Note
z If you need to correct the alignment of the leading
edge, press the Online button to display Offline, press
the [] button to feed the media, then select Force
Cutting on MAIN MENU to cut the leading edge.
(→ P. 7 -3 )
z After switching roll media and specifying a new media
type, please set the media type on the printer
operation panel. (→ P.2- 3 2)
Data
Information Power
Offline
Menu
Message
Online
Cleaning
(3 sec.)
Stop/Eject
(1 sec.)