Filter
Top Products
TELEDYNE API
Operating The M703E over the Serial I/O Ports M703E Calibrator Operator’s Manual
Press the following keys to select communication modes for a one of the COMM Ports, such as the following
example where
RS-485 mode is enabled:
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
SETUP X.X PRIMARY SETUP MENU
O3 SEQ CFG CLK PASS MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X COMMUNICATIONS MENU
ID COM1 COM2 EXIT
SETUP X.X COM1 MODE:0
<SET SET> EDIT EXIT
SETUP X.X COM1 QUIET MODE:OFF
PREV NEXT OFF EXIT
EXIT discards the new
setting
ENTR accepts the
new setting
SETUP X.X COM1 RS-485 MODE:OFF
PREV NEXT OFF ENTR EXIT
Activate / Deactivate
the Selected mode
by toggling the ON /
OFF key
SETUP X.X COM1 RS-485 MODE:ON
PREV NEXT OFF ENTR EXIT
Continue pressing NEXT until ...
Use the PREV and
NEXT Keys to
between the
available modes
PREV and NEXT Keys to continue selecting other
COM modes you want to enable or disable
Combined Mode ID
displayed here
92 05744 Rev B