Filter
Top Products
TELEDYNE API
M703E Calibrator Operator’s Manual Operating the M703E Calibrator
6.5.1.3. Setting the Repeat Count for a Sequence
The sequence can be set to repeat a certain number of times, from 1 to 100. It can also be set to repeat
indefinitely by inputting a zero (0) into the
REPEAT COUNTER.
To set th
e REPEAT COUNTER, press:
SETUP X.X REPEAT COUNT:1
<SET SET> EDIT EXIT
SETUP X.X NAME:[0]
0 0 1 ENTER EXIT
EXIT discards the
new NAME
ENTR accepts the
new NAME
Toggle these keys to set the repeat count from 1 to 100.
Enter “0” to cause the sequence to loop indefinitely
Continue pressing SET> until ...
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
Make sure that the M703E
is in standby mode.
SETUP X.X PRIMARY SETUP MENU
O3 SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT EXIT
SETUP X.X END OF SEQUENCES
INS PRNT EXIT
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
This display only appears if there are no sequences currently
programmed into the M703E.
OTHERWISE ...
05744 Rev B 43