Filter
Top Products
Model M703E
Calibrator
Operator’s
Manual
Warranty/Repair
Questionnaire
Model 703E
TELEDYNE API CUSTOMER SERVICE
EMAIL: api-customerservice@teledyne.com
PHONE: (858) 657-9800 TOLL FREE: (800) 324-5190 FAX: (858) 657-9816
05747 Rev B C-1
CUSTOMER:_______________________________ PHONE: _____________________________________
CONTACT NAME: __________________________ FAX NO. _____________________________________
SITE ADDRESS:____________________________________________________________________________
MODEL TYPE: ______________ SERIAL NO.:_________________ FIRMWARE REVISION:_____________
Are there any failure messages? _______________________________________________________________
_________________________________________________________________________________________
__________________________________________________________________________________________
__________________________________________________________________________________________
________________________________________________________________________
(Continue on back if necessary)
PLEASE COMPLETE THE FOLLOWING TABLE:
PARAMETER RECORDED VALUE ACCEPTABLE VALUE
ACT
PPB
1% OF TARG
TARG
PPB
50 – 1000 PPB
OUTPUT FLOW
LPM
2 – 5 LPM
REG PRESSURE
PSIG
15 ± 2 PSIG @ 5 LPM
BOX TEMP
ºC
20 – 35 ºC
O
3
GEN REF
mV
0 – 5000 mV
O
3
GEN DRIVE
mV
0 – 5000mV
O
3
LAMP TEMP
ºC
48 ± 1 ºC
PHOTO MEASURE
mV
2500 – 4700 mV
PHOTO REFERENCE
mV
2500 – 4700 mV
PHOTO FLOW
LPM
0.720 – 0.880 LPM
PHOTO LAMP TEMP
ºC
58 ± 1 ºC
PHOTO SPRESS
IN-HG-A
-1” AMBIENT IN-HG-A
PHOTO STEMP
ºC
25 – 48ºC
PHOTO SLOPE
1 ± 0.15
PHOTO OFFSET
PPB
0 ± 10 PPB
Depending on options installed, not all test parameters shown below will be available in your calibrator)
1
If ozone generator option installed.
2
If photometer option installed.
3 i
f permeation tube installed.
What is measured photometer flow rate ____________________________________________________ cc
3
/min
What is measured O
3
generator flow rate? _________________________________________________ cc
3
/min
What is the photo reference value while generating SPAN: __________________ ZERO:__________________