Filter
Top Products
TELEDYNE API
Operating the M703E Calibrator M703E Calibrator Operator’s Manual
6.3. STANDBY MODE
When the M703E Photometric Calibrator is in standby mode, it is at rest.
Some functions under the
SETUP MORE DIAG submenu, those which conflict with accurate
creation of calibration gas mixtures (e.g.
ANALOG OUTPUT STEP TEST) automatically place the
calibrator into
STANDBY mode when activated
NOTE
The M703E calibrator should always be placed in STANDBY mode when not needed to produce
calibration gas.
This can be done manually by pressing the STBY button that appears when the calibrator’s display is
showing the top-level menu (see Figure 6-1).
When programming a calibration sequences the STANDBY step should always be inserted at the end of
the sequence.
38 05744 Rev B