Filter
Top Products
TELEDYNE API
Operating the M703E Calibrator M703E Calibrator Operator’s Manual
To set the delta timer, press:
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
Make sure that the M703E
is in standby mode.
SETUP X.X PRIMARY SETUP MENU
O3 SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT EXIT
SETUP X.X END OF SEQUENCES
INS PRNT EXIT
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Continue pressing SET> until ...
This display only appears if there are no sequences currently
programmed into the M703E.
OTHERWISE ...
SETUP X.X TIMER DELTA: 001:00:00
<SET SET> EDIT EXIT
SETUP X.X TIMER DELTA: 0 Days
0 0 0 ENTR EXIT
Toggle these keys to enter
number of days to wait
between before running
sequence again.
EXIT discards the
new setting
ENTR accepts the
new setting
SYSTEM TIMER DELTA 00:00
1 2 :0 0 ENTR EXIT
HOUR MINUTE
Toggle these keys
to enter the starting
time
EXIT discards the
new setting
ENTR accepts the
new setting
Scrolls back and forth between
existing sequences
46 05744 Rev B