Filter
Top Products
TELEDYNE API
Operating the M703E Calibrator M703E Calibrator Operator’s Manual
6.5.2.5. The CC OUTPUT Step
This instruction causes the sequence to set or reset the M703E’s digital control outputs. It is very useful in
situations where the control outputs are being used to trigger other devices that need to be turned off and on in
synch with the operation of the calibrator as it progress through the sequence.
To insert a
CC OUTPUT step into a sequence, press:
SETUP X.X CC OUTPUT:DISABLED
<SET SET> EDIT EXIT
SETUP X.X CC OUTPUT:[0]00000000000
<CH CH> [0] ENTER EXIT
EXIT discards the
new setting
ENTR accepts the
new setting
SETUP X.X CC OUTPUT ENABLE:OFF
OFF ENTER EXIT
Toggle this key
turn the CC input
ON/OFF
Toggle this key to turn the
selected bit ON/OFF
(0 or 1)
Moves the
cursor one
character left or
right.
INSERT STEP Submenu
SETUP X.X INSERT STEP: GENERATE
PREV NEXT ENTR EXIT
Starting at the STEPS Submenu
Use the PREV and NEXT keys to scroll though the
list of available instructions
SETUP X.X INSERT STEP: PURGE
ENTR EXIT
SETUP X.X 2) SET CC OUTPUT 000100010110
PREV NEXT INS DEL EDIT EXIT
54 05744 Rev B