Filter
Top Products
TELEDYNE API
Operating The M703E over the Serial I/O Ports M703E Calibrator Operator’s Manual
94 05744 Rev B
7.1.6. MACHINE ID
Each type of Teledyne Instruments calibrator is configured with a default ID code. The default ID code for all
M703E calibrators is
700. The ID number is only important if more than one calibrator is connected to the same
communications channel such as when several calibrators are on the same Ethernet LAN, in a RS-232 multidrop
chain (See Section 7.3) or operating over a RS-485 n
etwork (Se
e Section 7.4). If two calibrators of the same
model type are used on one channel, the ID codes of one or both of the instruments needs to be changed so
To edit the instrument’s ID code, press:
nnel
odel type are used on one channel (for example, two M703E’s), the
ID of one instrument needs to be changed.
identify any one of several calibrators attached to the same network but situated
in different physical locations.
The ID number is only important if more than one calibrator is connected to the same communications cha
(e.g., a multi-drop setup). Different models of Teledyne Instruments’ calibrators have different default ID
numbers, but if two calibrators of the same m
The ID can also be used for to