Filter
Top Products
TELEDYNE API
Getting Started M703E Calibrator Operator’s Manual
VENTILATION CLEARANCE: Whether the calibrator is set up on a bench or installed into an instrument rack,
be sure to leave sufficient ventilation clearance.
AREA MINIMUM REQUIRED CLEARANCE
Back of the instrument 10 cm / 4 inches
Sides of the instrument 2.5 cm / 1 inch
Above and below the instrument. 2.5 cm / 1 inch
Various rack mount kits are available for this calibrator. See Chapter 5 of this manual for more information.
3.1.1. MODEL 703E CALIBRATOR
MODE FIELD
KEY DEFINITION FIELD
MESSAGE FIELD
STATUS LED’s
KEYBOARD
ON / OFF SWITCH
FASTENER
FASTENER
LOCKING SCREW
Figure 3-1: M703E Front Panel Layout
O
3
Generator
Exhaust
AC Power
Connector
Analog Output
Serial No. Tag
COMM Ports
Control Inputs
Optional Ethernet
Card
FAN
Control Outputs
Status Outputs
DCE-DTE
Switch
Photomete
r
Gas
Connectors
Cal Gas
Outlets
Photometer
O
3
Inlet
O
3
Outlet to
Photometer
Inlet for
Dry Air
Inlet for External
Zero Air Source
Figure 3-2: M703E Rear Panel Layout
10 05744 Rev B