Filter
Top Products
TELEDYNE API
M703E Dynamic Dilution Calibrator Operator’s Manual Optional Hardware and Software
5.2.4. ETHERNET (OPT 63)
The ETHERNET option allows the calibrator to be connected to any Ethernet local area network (LAN) running
TCP/IP. The local area network must have routers capable of operating at 10BaseT. If Internet access is
available through the LAN, this option also allows communication with the instrument over the public Internet.
Maximum communication speed is limited by the RS-232 port to 115.2 kBaud.
When installed, this option is electronically connected to the instrument’s COM2 serial port making that port no
longer available for RS-232/RS-485 communications.
The option consists of a Teledyne Instruments designed Ethernet card (see Figures 5-7 and 5-8), and a 7-foot
long CAT-5 network cable, terminated at both ends with standard RJ-45 connectors.
Figure 5-2: M703E Ethernet Card
Rear Panel
(as seen from inside)
CPU
Card
Ethernet
Card
Female RJ-45
Connector
R
S-232
Connector To
Motherboard
LNK LED
ACT LED
TxD LED
RxD LED
Interior View Exterior View
Figure 5-3: M703E Rear Panel with Ethernet Installed
For more information on setting up and using this option, see Section7.5
05744 Rev B 31