Filter
Top Products
TELEDYNE API
M703E Calibrator Operator’s Manual Operating the M703E Calibrator
05744 Rev B 81
6.12.5. PROGRAMMING NEW LEVELS
To begin programming a new LEVEL find the LVL submenu by pressing:
CHOOSE ACTION Submenu
SETUP X.X ACTION TO PERFORM:GENERATE
PREV NEXT ENTR EXIT
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
Make sure that the M703E
is in standby mode.
SETUP X.X PRIMARY SETUP MENU
O3 LEVL SEQ CFG CLK PASS MORE EXIT
SETUP X.X END OF LEVELS
INS PRNT EXIT
SETUP X.X [LEVEL ID] ) [Gas/Conc.], [Status Block Set]
PREV NEXT INS DEL EDIT PRNT EXIT
Deletes the LEVEL shown
in the message field
Edits the LEVEL shown in
the message field
Scrolls back and forth between
existing LEVELS
This display only appears if there are no LEVELs currently
programmed into the M703E.
OTHERWISE ...
Use these keys to scroll though the available
instructions: GENERATE & MANUAL