Filter
Top Products
Preparation
I ENGLISH
+ The amount of continuousrecording time available dependson
The type and capacity ofthe Batterypack you areusing.
How often the zoomfunction is used.
It is recommended that you have several batteries available.
Charging the Lithium Ion Battery Pack
1. Attach the Batterypack to the Camcorder.
2. Connect theAC Power adapter to an ACCord and connectthe AC Cord to
awall socket.
3. Connect the DC cable to the DCjack on the Camcorder.
4. Turnthe Power switchto OFF, and the chargingindicatorwill startto flash,
showingthat thebattery ischarging.
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50% ~ 75%
Three times per second 75% ~ 90%
Blinking stops and stays on 90% ~ 100%
On for a second and Error - Reset the Battery pack and
offfor a second the DC cable
5. When the battery is fully charged,disconnect the Batterypack and the AC Poweradapter from
the Camcorder. '-
Even with the Power switched OFF, the Battery pack will still discharge. <ChargingIndicator>
[ Notes ]
• The Battery pack may be charged a little at the time of purchase.
• To prevent reduction in the life and capacity of the Battery pack, always remove it from the Camcorder after it is fully charged.
• The amount of continuous recording time available depends on:
- The type and capacity of the Battery pack you are using.
- How often the zoom is used.
- Type of use (Camcorder/Camera/With LCD screen etc.).
- Ambient temperature.
It is recommended to have additional battery packs available.
• Even when the Power switched to OFF, the Battery pack will still discharge if it is left attached to the device.