Filter
Top Products
CHAPTER 12: COMMAND LINE INTERFACE 113
The Remote LDAP Server user’s configuration should be:
Dialback with remote TACACS user. (Tacacs+ v.4.0.3a)
Dialin and Dialback should be enabled on the device used for modem communication. Primary
(or/and Secondary) Tacacs Server Settings should be configured correctly and enabled on the SX
device:
Primary Server
Enabled - true
IP Address - 10.0.0.188
Port - 49
Secret - alabala
On the Remote Tacacs Server user’s configuration should own the following line:
user-dialback='129'
Configuring Network
The network menu commands are used to configure the SX network adapter.
Table 15 Configuration: Network Commands
COMMANDS DESCRIPTION
ethernetfailover
Enable/Disable network failover
interface
Configure the SX unit network interface.
ipfowarding
IP forwarding configuration
name
Network name configuration
ports
Network port configuration
route
Show kernel routing table
routeadd
Add route to kernel routing table
routedelete
Delete route of kernel routing table
Ethernetfailover Command
The ethernetfailover command is used to enable and disable the ability to failover from one
LAN to another.
The syntax of the ethernetfailover command is:
ethernetfailover <enable|disable> <interval>