Filter
Top Products
CHAPTER 12: COMMAND LINE INTERFACE 119
1. The following example configures DPA port settings when the Administrator chooses DPA
mode TCPPort. The Administrator needs to set the SSH or Telnet port value assigned for
direct port access:
admin > Config > Port > config port 1 ssh 7700 telnet 8800
Port 1: Configuration Saved
DPA changes will not be available until after the SX is
rebooted.
Other DPA TCPPort options:
config <port *> <ssh tcpport>
config <port portnumber> <ssh tcpport>
config <port port_range> <ssh tcpport>
config <port *> <telnet tcpport>
config <port portnumber> <telnet tcpport>
config <port port_range> <telnet base_tcpport>
For configuring all ports using a block of contiguous port numbers, <port *> command can be
used. If port_range is specified, then a block of contiguous port numbers will be used. The given
value of base_tcpport is used as starting value. For individual port configuration, the <port
portnumber> command can be used.
Ports Keywordadd Command
Keywords can be configured per port. After a keyword is configured for a port, an SMTP
notification, if the corresponding event is selected for notification, is sent upon detecting this
keyword in the data coming from the target connected to the port.
The syntax of the keywordadd command is:
keywordadd
The command options are described in Table 25.
Table 25 Port Keywordadd Command
COMMAND OPTION DESCRIPTION
Command Example
admin > ports > keywordadd
Ports Keyworddelete Command
The keyworddelete command removes an existing keyword.
The syntax of the keyworddelete command is:
keyworddelete
The command options are described in Table 26.
Table 26 Port Keyworddelete Command
COMMAND OPTION DESCRIPTION