Filter
Top Products
78 DOMINION SX USER GUIDE
Configuring SNMP Logging
The DSX supports Simple Network Management Protocol (SNMP) traps and logging.
Enable SNMP Logging
To enable SNMP logging:
1. Click the Setup tab, and then click SNMP. The SNMP screen appears.
2. Go to the SNMP Setting panel and click the Enable SNMP checkbox to enable the SNMP
feature.
Figure 73 SNMP Settings Panel
3. Type an SNMP public community in the Public Community field. The default is Public.
The public community determines which SNMP management stations receive SNMP alerts.
4. Click OK.
Create a New SNMP Destination
SNMP destinations determine which SNMP management stations receive SNMP traps. To create
a new SNMP destination:
1. Go the SNMP Destination panel and type the IP address of the new destination in the IP
Address field.
Figure 74 SNMP Destination Panel
2. By default, the new destination will use the standard SNMP port of 162. You can change this
to another port, if you wish, by entering a different port number in the Port field.
3. Click OK.
Note: To display the SNMP Management Information Base (MIB), click the View SNMP-MIB
link in the SNMP Settings panel (Figure 73).