Filter
Top Products
CHAPTER 4: NETWORK SETTINGS AND SERVICES 19
Add a New Static Route
To add a new Static Route:
1. Click the Setup tab, and then click Static Routes. The Static Routes screen appears. It
consists of an Enable IP Forwarding panel and a Static Routes List.
Figure 16 Static Routes List
2. Go to the Static Routes List and click Add New Route. The Static Route screen appears.
Figure 17 Static Route Screen
3. On a DSX with one LAN interface, LAN1 appears automatically in the Interface field. On a
DSX with two LAN interfaces, select the one you want from the drop-down menu In the
Interface field.
• LAN1 = eth0
• LAN2 = eth1
4. Type the IP address, subnet mask, and gateway of the destination host in the Destination,
Mask and Gateway fields.
5. Type the TCP maximum segment size (MSS) in bytes in the MSS field.
6. Type the TCP windows size for connections over this route in bytes in the Window field.
7. Type the initial round trip time (IRTT) for TCP connections over this route in
milliseconds(1-12000) in the IRTT field.
8. Select your route type from the Flags drop-down menu.
• Host means this route is for a host machine.
• Net means this route it for a subnet.
9. Click OK.