Filter
Top Products
CHAPTER 14: POWER CONTROL 167
Scenario #1 Turn ON Group Association
Pre-condition Administrator user is logged in via CLI.
Administrator is in power menu.
Group Association named Group1 (shown in Fg.1) is already created.
Action 1. Enter Command.
2. Press Enter.
CLI Input Command: on nodegroup Group1
Scenario #2 Turn ON Group Association (outlets in association are with different
statuses)
Pre-condition Administrator user is logged in via CLI.
Administrator is in power menu.
Group Association named Group1 (shown in Fg.1) is already created.
Outlets in Group1 are with different statuses.
Action 1. Enter Command.
2. Press Enter.
CLI Input Command: on nodegroup Group1
Scenario #3 Turn OFF Group Association
Pre-condition Administrator user is logged in via CLI.
Administrator is in power menu.
Group Association named Group1 (shown in Fg.1) is already created.
Action 1. Enter Command.
2. Press Enter.
CLI Input Command: off nodegroup Group1
Scenario #4 Turn OFF Group Association (outlets in association are with different
statuses)
Pre-condition Administrator user is logged in via CLI.
Administrator is in power menu.
Group Association named Group1 (shown in Fg.1) is already created.
Outlets in Group1 are with different statuses.
Action 1. Enter Command.
2. Press Enter.
CLI Input Command: off nodegroup Group1
Scenario #5 Recycle Group Association
Pre-condition Administrator user is logged in via CLI.
Administrator is in power menu.
Group Association named Group1 (shown in Fg.1) is already created.
Action 1. Enter Command.
2. Press Enter.
Target1 Target2
SX
Fg.1
G
rou
p
1
PowrStr2
PowrStr1