Filter
Top Products
CHAPTER 12: COMMAND LINE INTERFACE 125
SSH Command
The syntax of the ssh command is:
ssh [enable <true|false>] [port value]
The ssh command options are described in Table 31.
Table 31 SSH Command
COMMAND OPTION DESCRIPTION
enable <true|false>
Enable or disable SSH access.
port value
SSH server tcp listen port
SSH Command Example:
admin > Config > Services > ssh enable true port 4
The system displays this message after entering the preceding command:
The system will need to be rebooted for changes to take effect.
Telnet Command
The syntax of the telnet command is:
telnet [enable <true|false>] [port value]
The telnet command options are described in the following table.
Table 32 Telnet Command
COMMAND OPTION DESCRIPTION
enable <true|false>
Enable or disable Telnet access.
port value
Telnet server tcp listen port
Telnet Command Example
The command below enables telnet access on port 23.
admin > Config > Services > telnet enable true port 23
Configuring SNMP
The Dominion SX server supports sending SNMP alerts to a predefined SNMP server. The
Raritan SNMP MIB may be obtained from the FAQs in the support section of the Raritan web
site. (http://www.raritan.com/_downloads/SX-MIB.txt
). The following commands configure the
SNMP features:
• add
• delete
• snmp
SMNP Add Command
The add command adds trap recipients. A recipient is an IP address with an optional space-
separated port
number. Traps may be sent to multiple ports with the same IP address.