Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-2 Preparing for Use with PC
Install the driver for TWAIN-compliant PC applications and the
camera back calibration (CAL) file on your PC.
Insert (and remove) your PCMCIA card into the DCS 465 Camera
Back.
Access the driver for TWAIN-compliant PC applications.
Update camera back firmware.
Format a PCMCIA card for use with the camera back.
IMPORTANT: We assume that you are familiar with the operation of your PC.
If you are not, refer to the manuals that accompany that computer before continu-
ing.
Before you continue, if you have not completed and returned the enclosed
Warranty Registration card, please do so now.
CAUTION: In this chapter you will connect the camera back to
your computer. Once connected, do not disconnect the camera
back from the computer while using the supplied software, or
even while the computer is on. Doing so may result in the loss of
data from the PCMCIA card in the camera back or from the hard
disk in your computer. Instead, turn off all equipment in the order
described at the end of this chapter before disconnecting the
camera back.