Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-48 Preparing for Use with PC
Updating Firmware in the DCS 465
Camera Back
The DCS 465 Camera Back incorporates nonvolatile memory that con-
tains controls — called firmware — for most features of the camera back.
You can update that firmware yourself, which means you can keep the
camera back up-to-date as changes are made to the firmware. (Refer to
the appendix “Updating Your Kodak Software Driver,” for additional
information.) You can also perform some troubleshooting without sending
the camera back to a service center, as described in the camera back
troubleshooting section of this manual.
By following the steps below to update camera back firmware the first
time you use the TWAIN driver, you will ensure that the camera back
contains the most current version of the firmware. You do not need to
update camera back firmware each time you use the driver.
NOTE: To complete these steps, the camera back must be connected to your PC
as described earlier in this chapter. We also assume that one of the software
applications described earlier in this chapter is currently running on your PC, and
that you have accessed the driver image window, which is shown on the next
page.