Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Reference — KODAK Drivers for TWAIN-Compliant PC Applications 11-41
The KODAK DCS 465
Camera choice does not
appear in your software.
You have not installed
the driver software.
Install the driver.
The time and/or date in
the information box for an
image(s) is incorrect.
The computer system
clock from which the
clock in the camera
back was set, contained
an incorrect time and/or
date.
Reset the computer system
clock. Connect the DCS 465 to
your computer, run the driver,
and reset the clock in the
camera back using the Set
Clock choice on the Control
Panel.
The battery has been
dead for an extended
period (perhaps a month
or more) without
recharging.
Recharge the camera back
battery with the AC battery
charger/adapter, and then reset
the clock in the camera back
using the Set Clock choice on
the Control Panel.
You are unable to open
the software driver when
you choose its name in
your application while the
camera back is connected
to the computer.
The firmware in the
camera back has
become corrupted.
Update camera back firmware
as described earlier in this
chapter.
The TWAIN driver is not
working or not working
properly.
There is insufficient
RAM for the TWAIN
driver.
Set the memory preference for
your application (often found on
the File menu) so that there is at
least one megabyte of free
RAM. (Some image editing
software takes all available
RAM by default at startup.)
Troubleshooting — Kodak Driver for
TWAIN-Compliant PC Applications
Trouble Possible Cause Suggested Solution