Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-2 Preparing for Use with Mac
Install the driver for Adobe Photoshop Software and the camera back
calibration file (CAL) on your Macintosh computer.
Insert (and remove) your PCMCIA card into the DCS 465 Camera
Back.
Access the driver for Adobe Photoshop Software.
Update camera back firmware.
Format a PCMCIA card for use with the camera back.
IMPORTANT: We assume that you are familiar with the operation of your
Macintosh computer. If you are not, refer to the manuals that accompany that
computer before continuing.
Before you continue, if you have not completed and returned the enclosed
Warranty Registration card, please do so now.
CAUTION: In this chapter you will connect the camera back to
your computer. Once connected, do not disconnect the camera
back from the computer while using the supplied software, or
even while the computer is on. Doing so may result in the loss of
data from the PCMCIA card in the camera back or from the hard
disk in your computer. Instead, turn off all equipment in the order
described at the end of this chapter before disconnecting the
camera back.