Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Preparing for Use with Mac 4-45
Updating DCS 465 Camera Back
Firmware
The DCS 465 Camera Back incorporates nonvolatile memory that con-
tains controls — called firmware — for most features of the camera back.
You can update that firmware yourself, which means you can keep the
camera back up-to-date as changes are made to the firmware. (Refer to
the appendix “Updating Your Kodak Software Driver,” for additional
information.) You can also perform some troubleshooting without sending
the camera back to a service center, as described in the camera back
troubleshooting section of this manual.
By following the steps below to update camera back firmware the first
time you use the Photoshop driver, you will ensure that the camera back
contains the most current version of the firmware. You do not need to
update camera back firmware each time you use the driver.
NOTE: To complete these steps, the camera back must be connected to your
Macintosh computer as described earlier in this chapter. We also assume that
Adobe Photoshop is currently running on your Macintosh computer, and that you
have accessed the driver image window by choosing KODAK DCS 465 from the
A
CQUIRE submenu of the Adobe Photoshop FILE menu.