Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
11-32 Reference — KODAK Drivers for TWAIN-Compliant PC Applications
“Command failure:
Unable to free resource
from global memory.”
A problem has occurred
with Windows.
Restart your computer and try
again.
If this does not resolve the
problem, obtain technical
support from your Windows
supplier.
“Connect the battery
charger, if it is not already
connected, and wait 3
minutes.
“If the charger is already
connected, then wait 3
minutes before
Downloading Firmware.”
The battery does not have
enough power to update
the camera back
firmware.
Allow the camera back battery to
charge for three minutes from the
AC battery charger/adapter, and
then click Update Camera
Firmware again.
“Could not acquire this
image because
informational data was
invalid.”
You have tried to acquire
a blank image, or an
image that has been
corrupted.
Blank images cannot be
acquired. Work with another
image.
If it is not a blank image, you
may not be able to acquire this
image.
“Could not save any
images. All images had
bad informational data.”
You have tried to save a
blank image, or an image
that has been corrupted.
Blank images cannot be saved to
an archive folder. Work with
another image.
If it is not a blank image, you
may not be able to acquire this
image.
“Data transfer from
DCSxxx is incomplete.”
There has been an
interruption in data
transfer between the
camera back and the
computer.
Verify that the SCSI cable is
connected properly between the
camera back and the computer.
If not, turn both off, reconnect
them, and try again.
“DCS (Digital Camera
System) has been
disconnected.”
The camera back and the
computer have been
disconnected.
Turn off the camera back and the
computer, reconnect them, and
try again.
Message Possible Cause Suggested Solution