Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-12 Preparing for Use with PC
Setting the SCSI ID on the DCS 465
Camera Back
In this section you will set the SCSI identification (ID) number for the DCS
465 Camera Back. Each SCSI device connected to the same computer
must have a different ID number.
IMPORTANT: This section assumes that the camera back and the computer are
not currently connected. You should never change the SCSI ID on the DCS 465
Camera Back when it is connected to a computer.
1. Shut down your PC.
2. If SCSI devices other than the DCS 465 Camera Back are connected to
your PC, determine their SCSI identification numbers so that you can
select a different number for the DCS 465 Camera Back. If necessary,
refer to the instructions for those devices to determine how to find
their numbers.
NOTE: Since you may connect the camera back to different computers, or
since you may change the external devices connected to a PC you regularly
use with the camera back, you should ensure that the DCS 465 Camera Back
has a unique SCSI ID each time you connect it to a PC.