Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Preparing for Use with PC 5-21
7. Attach the other end of the cable (25-pin SCSI connector) to the SCSI
port on the DCS 465 Camera Back.
SCSI Port
8. (Optional) Later, to disconnect the camera back from the PC, shut
down the PC. Then disconnect the terminator from the camera back.
Disconnect the SCSI cable from the PC. Do not leave a SCSI cable
with an empty connector dangling from your PC.
Skip the next section and continue at “KODAK Drivers for TWAIN-
Compliant PC Applications” later in this chapter.
DCS 465 Camera Back Used with Other SCSI
Devices
NOTE: If other external SCSI devices are connected to your computer, you may
need to obtain a SCSI terminator to complete these steps.
Follow these steps if one or more external SCSI devices are already
connected to your PC; otherwise, continue at the next section of this
manual entitled “KODAK Drivers for TWAIN-Compliant PC Applications”
later in this chapter.