Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-26 Preparing for Use with PC
B. Follow these steps if the last connected
device is terminated internally.
1. Turn off the PC, and all connected SCSI devices.
IMPORTANT: Later when you connect and disconnect the PC and the DCS
465 Camera Back on a regular basis, make sure that all devices are off.
2. Place the DCS 465 Camera Back in a convenient position next to the
last device in the SCSI chain of devices connected to your PC.
3. Connect the AC battery charger/adapter to the camera back as de-
scribed in “Charging Batteries and Using the AC Battery Charger/
Adapter” earlier in this chapter. Although this step is optional, we
recommend it whenever the camera back is connected to a computer.
4. Select the SCSI cable with the 50-pin connector at one end and the
25-pin connector at the other end.
IMPORTANT: Use only the cable supplied with the DCS 465 Camera Back;
do not use a substitute cable.
25-pin Connector50-pin Connector