Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-22 Accessing Images from a Mac
Quitting
Complete these steps when you have completed your work with the DCS
465 Camera Back and the Macintosh computer.
NOTE: As mentioned at the start of this chapter, the settings you choose while in
the driver image window are maintained, and will be in effect the next time you
enter the driver image window.
1. (Optional) Choose KODAK DCS 465 again from the ACQUIRE submenu
to return to the driver image window; copy/move images to the
Macintosh hard disk, and delete unwanted images. Deleting images
will make room on the PCMCIA card for additional images.
2. Acquire additional images or choose CANCEL to leave the driver
image window.
3. Save opened Photoshop acquired images as desired.
IMPORTANT: Recall as described earlier in this chapter that if you have not
made any changes to an acquired image while in Photoshop, and you quit
Photoshop, the window will close without asking you if you want to save it.
Therefore, be sure you use one of the S
AVE commands from the FILE menu to
save any acquired images you do not want to lose before quitting Photoshop.
4. Choose QUIT from the Photoshop FILE menu.
5. Choose S
HUT DOWN from the Macintosh SPECIAL menu.
6. Turn off other SCSI devices if present.
7. (Optional) Disconnect the AC battery charger/adapter if it is con-
nected.
8. (Optional) Disconnect the DCS 465 Camera Back from the computer.