Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Preparing for Use with PC 5-19
Making the SCSI Connection
The DCS 465 Camera Back is a non-terminated SCSI device that connects
to your PC at a SCSI2 connection on your PC. In normal usage you may
connect and disconnect the DCS 465 Camera Back from the PC on a
regular basis; for this reason you may want to position your computer so
that its SCSI2 connector is readily accessible.
Continue below at “DCS 465 Camera Back as the Sole SCSI Device” (this
page), at “DCS 465 Camera Back Used with Other SCSI Devices,” or at
“DCS 465 Camera Back Used with a Laptop” as appropriate to match
your intended configuration.
DCS 465 Camera Back as the Sole SCSI Device
1. Turn off the PC.
IMPORTANT: Later when you connect and disconnect the PC and the DCS
465 Camera Back, make sure that the PC is off.
2. Place the DCS 465 Camera Back in a convenient position next to
your PC.
3. Connect the AC battery charger/adapter to the camera back as de-
scribed earlier in this chapter. Although this step is optional, we
recommend it whenever the camera back is connected to a computer.
4. Select the SCSI cable with the 50-pin SCSI2 HD connector at one end
and the 25-pin SCSI connector at the other end.
IMPORTANT: use only the cable supplied with the camera back; do not use
a substitute cable.
25-pin SCSI Connector50-pin SCSI2 HD Connector