Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessing Images from a Mac 7-3
Accessing the DCS 465 Camera Back
from the Driver
Repeat the steps below each time you want to access the camera back
from the Kodak Driver for Adobe Photoshop Software.
1. If the DCS 465 Camera Back and your Macintosh computer are not
connected, turn the computer off and connect them now by following
the directions in chapter 4.
2. Connect the AC battery charger/adapter to the camera back as de-
scribed in chapter 4. Although this step is optional, we recommend it
whenever the camera back is connected to a computer.
3. With the computer off, turn on the DCS 465 Camera Back by pressing
the record button, or operate the camera back while connected to the
AC battery charger/adapter which places the camera back in a con-
tinual awake state.
4. Turn on the Macintosh computer.
5. Wait until you are in the Finder.
6. If one is not present, insert a PCMCIA card into the camera back.
NOTES: As you work with the camera back and the computer, you can insert
and remove cards at any point in the process; however, do not remove a
PCMCIA card while the red Card Busy light on the camera back is blinking. If
you do, you may lose all data on the card.
Use extreme care with PCMCIA cards, as they are easily damaged — espe-
cially if dropped. If dropped, you may destroy the PCMCIA card resulting in
the loss of all of your data on the card.
7. Run Adobe Photoshop.