Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Preparing for Use with Mac 4-25
4. Attach the 25-pin connector of the 25-pin to 50-pin SCSI cable that
you have supplied to the SCSI port on the back of the Macintosh IIfx
computer. Make sure the connector is well seated by pressing it into
place firmly, and then tighten both knobs on the cable connector.
5. Attach either end of the 50-pin gender changer to the open, 50-pin
end of the SCSI cable attached to the Macintosh IIfx computer.
6. Attach your black terminator made especially for the Macintosh IIfx
computer to the open connector on the 50-pin gender changer.
7. Attach the 50-pin connector on the 25-pin to 50-pin SCSI cable
supplied with the camera back to the open end on the black termina-
tor.
8. Attach the 25-pin connector on the SCSI cable to the SCSI connector
on the back of the DCS 465 Camera Back.
9. (Optional) Later, to disconnect the camera back from the Macintosh
computer, shut down the computer. Then disconnect one SCSI cable
from the camera back. Disconnect the other SCSI cable from the
Macintosh computer. Do not leave a SCSI cable with an empty
connector/terminator dangling from your Macintosh computer.
Skip the next sections and continue at “Installing the KODAK Driver for
Adobe Photoshop Software (Macintosh) and the Calibration File” later in
this chapter.
DCS 465 Camera Back Used with Other SCSI
Devices
Follow these steps if one or more external SCSI devices are already
connected to your Macintosh computer; otherwise continue at the next
section of this manual entitled “Installing the KODAK Driver for Adobe
Photoshop Software (Macintosh) and the Calibration File.”